There are a few bugs in SD3. The Funkmaster Clyde EZX doesn't load in the mixer properly. Also all the 'presets' aren't correct either in this EZX. The same with Soul 60's and its presets. The sounds load in, but the mixer is incorrect. The Alt Rock 1 preset has a clap sound on the snare.
My other big issue is when I load a Drum/Mixer preset from SD3 and have the mixer set to 'stereo' it sounds fine. When I switch to multichannel and then back to stereo, all of the mixer effects are visible but those busses with effects don't play. I have to totally reload the preset. Even if I load it in and then load in the stereo mixer right after that, all those effects on the busses don't play because there is no signal going through them.
Finally is there a way to multichannel out the Mixer Outputs to different auxes in ProTools? Not the individual mixer channels, but the SD3 Mixer Outputs so I can take advantage of some of your effects on those Mixer Outputs.
Thanks!
